I did notice that the exhaust note seemed more audible in the car though. If the engine had reduced power, I wasn't really able to tell. I drove around the block and everything seemed fine. Unfortunately, the same error popped up again on the display.Īfter that, I thought well maybe the car just needs to drive around a little to relearn a value and that will fix it. I shut down the car, and started it back up to see if the problem was gone. I cleared the codes, and the light went away. Thinking that maybe I just needed to clear an error, I looked and sure enough there were two stored errors related to the DME/DDE. When I started my car back up, I got the orange half engine error on my cluster but the engine seemed to be running fine. I reset them using INPA with the engine off, ignition on. ![]() ![]() So I decided I wanted to reset all the engine adaptation values on my car to let it start fresh. ![]() OK This is going to be a long post, but I'd like to try and provide as much detail on the issue I'm having as possible from the getgo.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |